Pixhawk2.1 (Edison Carrier Board) + Here 2 GNSS (M8N)

Pixhawk2.1 (Edison carrier card) Here 2 GNSS (M8N)
Pixhawk2.1 (Edison carrier card) Here 2 GNSS (M8N)
This kit contains the following items:
A standard carrier plate (not compatible with Intel Edison Chip)
1 Power Brick (two power bricks can be larger to be redundant)
Set of cables that allows you to connect to your old telemetry module, GPS and sensors
Included in detail (the accessory cables are JST to DF13 cables that are compatible with the old pixhawk accessories, such as telemetry, Power Brick or GPS):
PIXHAWK2.1 Here 2 * 1
Carrier PIXHAWK2.1 * 1
POWER Brick Mini * 1
SD card (inserted in Cube) * 1
TELEM * 2 cable
Power cable * 1
I2C cable * 1
Cable BUZZER * 1
MICRO USB cable * 1
GPS1 cable (with security switch) * 1
GPS2 cable * 1
I2C divider * 1
Mounting screws (M2.5 * 8) * 4
3M double-sided foam tapes
For the detailed use of Intel Edison Chip
Please refer to:
http://ardupilot.org/dev/docs/intel-edison.html
This kit contains the following items
A complete transport table.
1 Power Brick
Set of cables that allows you to connect to your old telemetry module, GPS and sensors
Here GNSS.
Included in detail (the accessory cables are JST to DF13 cables that are compatible with the old pixhawk accessories, such as telemetry, Power Brick or GPS):
Here GNSS * 1
PIXHAWK2.1 Cube * 1
PIXHAWK2.1 Full Carrier Board * 1 (compatible with Intel Edison)
POWER Brick Mini * 1
SD card (inserted in Cube) * 1
TELEM * 2 cable
Power cable * 1
I2C cable * 1
Cable BUZZER * 1
MICRO USB cable * 1
GPS1 cable (with security switch) * 1
GPS2 cable * 1
I2C divider * 1
Mounting screws (M2.5 * 8) * 4
3M double-sided foam tapes