HERE3+ CAN GNSS GPS Module w/ iStand
The Hex Here3+ GPS is a cost-efficient GNSS system that supports RTK mode with positioning accuracy down to centimeter-level in an ideal environment. The Here3+ features high data rate, upgradeability, noise immunity, and real-time features from the DroneCAN protocol. Here3+ is now moving to DroneCAN 8Mbit bus speed and supports future firmware updates. Here 3 is equipped with the STM32F302 processor, while the Here3+ uses the dual-core STM32H757 running at 400MHz with 2MByte Flash and 1MByte RAM. Built-in IMU (compass, gyroscope, and accelerometer) for advanced navigation needs.
Features
- Equipped with STM32H757 high-performance processor in a real-time operating system. The framework developed by Hex provides additional stabilities. Supports future firmware updates.
- Cost-efficient high precision and RTK-supported GNSS chip (base station needed for RTK). Positioning accuracy down to centimeter-level in an ideal environment.
- Improved dust and water resistance (Not guaranteed to be water-proof under any situation due to the complexity of the operating environment).
- Complete built-in set of Inertial Measurement Units (compass, gyroscope, and accelerometer), which satisfy advanced navigation needs.
- The high data rate, upgradeability, noise immunity, and real-time features benefited from the CAN protocol.
- Support from ground control software. Future updates will be available from Mission Planner.
- Brand new design with improved visibility on signal LEDs.
- iStand Included.